Chapter 6: Using the Web Interface
238
Note: When creating scheduled actions, available actions are less
than usual because it is meaningless to schedule certain actions like
"Alarm," "Log event message," "Send email," "Syslog message" and
the like.
2.
Click
to schedule the desired
action.
a.
Assign a name to this scheduled action.
b.
Make sure the Enabled checkbox is selected, or the SRC does
not perform this scheduled action.
c.
Set the interval time, which ranges from every minute to yearly.
d.
In the 'Available actions' field, select the desired action(s).
e.
Click Create.
For details, see
Scheduling an Action
(on page 274).
Built-in Rules and Rule Configuration
SRC is shipped with four built-in event rules, which cannot be deleted. If
the built-in event rules do not satisfy your needs, create new rules.
Built-in rules:
System Event Log Rule:
This causes ANY event occurred to the SRC to be recorded in the
internal log. It is enabled by default.
Note: For the default log messages generated for each event, see
Default Log Messages
(on page 244).
System SNMP Notification Rule:
This causes SNMP traps or informs to be sent to specified IP
addresses or hosts when ANY event occurs to the SRC. It is disabled
by default.
System Tamper Detection Alarmed:
This causes the SRC to send alarm notifications if a DX tamper
sensor has been connected and the SRC detects that the tamper
sensor enters the alarmed state. It is enabled by default.
System Tamper Detection Unavailable:
This causes the SRC to send alarm notifications if a DX tamper
sensor was once connected or remains connected but then the SRC
does not detect the presence of the tamper sensor. It is enabled by
default.
Summary of Contents for Raritan SRC-0100
