LEGRAND Raritan SRC-0100, User Manual, Page: 189 / 698

Chapter 6: Using the Web Interface
177
Wireless Network Settings
If the device's cascading mode is set to 'Bridging' or its role is set to
'Slave' in the port forwarding mode, the wireless settings will be
disabled. See
Setting the Cascading Mode (on page 187).
By default the wireless interface is disabled. You should enable it if
wireless networking is wanted.
On the Network page, click the WIRELESS section to configure wireless
and IPv4/IPv6 settings.
Interface Settings:
Field/setting Description
Enable interface Enable or disable the wireless interface.
When disabled, the wireless networking fails.
Hardware state Check this field to ensure that the SRC has
detected a wireless USB LAN adapter. If not,
verify whether the USB LAN adapter is firmly
connected or whether it is supported.
SSID Type the name of the wireless access point (AP).
Force AP BSSID If the BSSID is available, select this checkbox.
BSSID Type the MAC address of an access point.
Enable High
Throughput
(802.11n) Enable or disable 802.11n protocol.
Authentication Select an authentication method.

No Authentication: No authentication data is
required.

PSK: A Pre-Shared Key is required.

EAP: Use Protected Extensible Authentication
Protocol. Enter required authentication data in
the fields that appear.
Pre-Shared Key
This field appears only when PSK is selected.
Type the PSK string.