13 - 38
Chapter 13 Control Sub Functions
13.4.5 Forced stop function
DANGER
When the forced stop is required to be wired, ensure to wire it in the negative logic using b-
contact.
Provided safety circuit outside the Simple Motion module so that the entire system will operate
safety even when the "
Pr.82 Forced stop valid/invalid selection
" is set "1: Invalid". Be sure to use the
forced stop signal (EMI) of the servo amplifier.
"Forced stop function" stops all axes of the servo amplifier with the forced stop signal.
(The initial value is set to "0: Valid".)
The forced stop input valid/invalid is selected by "
Pr.82 Forced stop valid/invalid
selection
".
The details shown below explain about the "forced stop function".
[1] Control details
[2] Wiring the forced stop
[3] Setting the forced stop
[4] How to check the forced stop
[5] Precautions during control
[1] Control details
When "
Pr.82
Forced stop valid/invalid selection
" is set to other than "1: Invalid", the
forced stop signal is sent to all axes after the forced stop input is turned on.
Refer to the servo amplifier instruction manual for the operation of the servo
amplifier after the forced stop signal is sent.
The outline of the forced stop process is shown below.
Stop cause
Stop
axis
M code
ON
signal
after stop
Axis
operation
status
(
Md.26
)
after
stopping
Stop process
OPR control
Major
positioning
control
High-level
positioning
control
Manual control
Machine
OPR
control
Fast OPR
control
JOG/
Inching
operation
Manual
pulse
generator
operation
Forced stop
"Forced stop input
signal" OFF from
an external device
All axes
No
change
Servo OFF
Immediate stop
Summary of Contents for MELSEC-L Series
