11 - 19
Chapter 11 Manual Control
11.3.3 Setting the required parameters for inching operation
The "Positioning parameters" must be set to carry out inching operation.
The following table shows the setting items of the required parameters for carrying out
inching operation. Parameters not shown below are not required to be set for carrying
out only inching operation. (Set the initial value or a value within the setting range.)
Setting item
Setting requirement
Factory-set initial value
(setting details)
Positioning para
m
eters
Pr.1 Unit setting
3 (PLS)
Pr.2 Number of pulses per rotation (AP) (Unit: PLS)
20000
Pr.3 Movement amount per rotation (AL) (Unit: PLS)
20000
Pr.4 Unit magnification (AM)
1 (1 times)
Pr.11 Backlash compensation amount (Unit: PLS)
0
Pr.12 Software stroke limit upper limit value (Unit: PLS)
2147483647
Pr.13 Software stroke limit lower limit value (Unit: PLS)
–2147483648
Pr.14 Software stroke limit selection
0 (current feed value)
Pr.15 Software stroke limit valid/invalid setting
0 (valid)
Pr.17 Torque limit setting value (Unit: %)
300
Pr.31 JOG speed limit value (Unit: PLS/s)
20000
: Setting always required.
: Set according to requirements (Set the initial value or a value within the setting range when not used.)
REMARK
Positioning parameter settings work in common for all controls using the Simple
Motion module. When carrying out other controls ("major positioning control",
"high-level positioning control", and "OPR control"), set the respective setting items
as well.
Parameters are set for each axis.
Refer to Chapter 5 "Data Used for Positioning Control" for the setting details.
Summary of Contents for MELSEC-L Series
