Rohde & Schwarz ZNB20, User Manual

Page: 426 / 1332

GUI Reference
R&S
®
ZNB/ZNBT
411 User Manual 1173.9163.02 ─ 38
Access: Overview Panel > "Impedance Renor."
For the "2-Port Data" network type, the required touchstone file can also be selected
from here ("...").
If necessary, use the button on the right hand side to open the Balanced Ports Dialog
and change the balanced port configuration.
This panel can also be activated by selecting the Differential Match Tab softtool tab.
Refer to its description of this softtool tab for background information, parameters and
additional remote commands.
Active
The checkboxes in the "Active" column activate or deactivate the configured differential
match embedding (i.e. adds or removes it to/from the calculation flow) without chang-
ing its parameters.
Remote command:
CALCulate<Ch>:TRANsform:VNETworks:DIFFerential:
EMBedding<LogPt>[:STATe]
5.7.2 Offset Tab
Defines length offset parameters for each port.
Use the complementary dock widget to activate or deactivate length/loss compensation
for selected ports (see
Chapter 5.7.1.2, "Offset Panel" , on page 406).
The marker function Zero Delay at Marker function overwrites the offset parameters.
Background information
Refer to the following sections.
●
Chapter 4.6, "Offset Parameters and Embedding" , on page 175
●
Chapter 4.6.1.1, "Definition of Offset Parameters " , on page 176
●
Chapter 4.6.1.3, "Auto Length" , on page 176
●
Chapter 4.6.1.6, "Application and Effect of Offset Parameters " , on page 180
●
Chapter 4.6.1.7, "Offset Parameters for Balanced Ports" , on page 181
●
Chapter 4.6.1.5, "Fixture Compensation " , on page 179
Offset Embed Softtool