Rohde & Schwarz ZNB20, User Manual

Page: 52 / 1332

Getting Started
R&S
®
ZNB/ZNBT
37 User Manual 1173.9163.02 ─ 38
1
2
12
3 4 5
8
13
11
14
7
6
9 10
15
16
17
Figure 3-4: R&S ZNB rear view
Table 3-1: Rear panel connectors available on all instruments
Index Label Description
1 (Power
I/O) Power on / off switch, see Chapter 3.1.7, "Starting the Analyzer and Shutting Down" ,
on page 18
2 LAN RJ-45 connector to integrate the instrument to a Local Area Network, primarily for
remote control purposes; see
Chapter 3.1.12.1, "Assigning an IP Address" ,
on page 24.
See also Chapter 10.2.2, "LAN Interface" , on page 1254.
3 USB /
USB Host
Two additional type A USB host connectors, similar functionality as the type A host
connectors on the front panel (see
"USB Connectors" on page 33).
●
USB 3.0, labeled "USB Host" for R&S ZNB40 variants 82 and 84
●
USB 2.0, labeled "USB" for all other R&S ZNB
4 Monitor
(Display-
Port) R&S ZNB40 variants 82 and 84 only
External monitor connector (DisplayPort); see Chapter 3.1.9.1, "Connecting a Moni-
tor" , on page 20.
5 USB
Device R&S ZNB40 variants 82 and 84 only
Type B USB 3.0 device (slave) connector for remote control of the instrument (see
Chapter 3.1.9.6, "Connecting an USB Cable for Remote Control" , on page 22)
6 Monitor
(DVI-D) External monitor connector (DVI-D); see Chapter 3.1.9.1, "Connecting a Monitor" ,
on page 20.
7 (User
port) 25-pin D-Sub connector used as an input and output for low-voltage (3.3 V) TTL
control signals
See Chapter 10.2.1.1, "USER PORT" , on page 1252.
8 EXT TRIG
IN / EXT
TRIG
OUT Two BNC connectors for 5 V TTL external trigger signals
See Chapter 5.6.1, "Trigger Tab" , on page 400.
Instrument Tour