Rohde & Schwarz ZNB20, User Manual

Page: 1097 / 1332

Command Reference
R&S
®
ZNB/ZNBT
1082 User Manual 1173.9163.02 ─ 38
Example: *RST
Reset the instrument, activating a frequency sweep with the S-
parameter S
21
as a measurement result for channel and trace
no. 1.
SWEep:TIME?
Query total sweep time.
SWEep:DWEL 1
SWEep:DWEL:IPOint ALL
Set a delay of 1 s for each partial measurement.
SWE:TIME?
Query total sweep time. The time is extended by the delay times
the total number of sweep points (one partial measurement per
sweep point required).
Manual operation: See "Meas Delay" on page 241
[SENSe<Ch>:]SWEep:DWELl:IPOint <InsertionPoints>
Defines whether the measurement delay (previously defined via
[SENSe<Ch>:
]SWEep:DWELl
) is inserted before all partial measurements or before the first partial
measurement only.
Suffix:
<Ch>
.
Channel number
Parameters:
<InsertionPoints> ALL | FIRSt
Insertion before all or before the first partial measurement
*RST:
ALL
Example: See
[SENSe<Ch>:]SWEep:DWELl
Manual operation: See "All Partial Meas'ments / First Partial Meas'ment"
on page 242
[SENSe<Ch>:]SWEep:GENeration <arg0>
Sets/gets the sweep mode for linear frequency sweeps.
For segmented sweeps this can be overridden by segment-specific sweep modes
(
[SENSe<Ch>:]SEGMent<Seg>:SWEep:GENeration
).
Suffix:
<Ch>
.
Channel number
Parameters:
<arg0> STEPped | ANALog
Stepped mode or swept mode (=ANALog).
*RST:
STEPped
Manual operation: See "Freq Sweep Mode" on page 242
SCPI Command Reference