Rohde & Schwarz ZNB20, User Manual

Page: 309 / 1332

GUI Reference
R&S
®
ZNB/ZNBT
294 User Manual 1173.9163.02 ─ 38
Background and related information
●
Refer to Chapter 4.5.7, "SMARTerCal" , on page 172 for backgound information
●
Use the Power Cal Wizard to perform an additional source flatness calibration (see
Chapter 4.5.7.3, "Combining SMARTerCal with Scalar Power Calibration" ,
on page 174).
●
When you apply the acquired "SMARTerCal", the active calibration is replaced and
discarded.
To persist any kind of calibration you can transfer it to the calibration "Pool" using
the
Calibration Manager Dialog .
●
The system error correction data determined in a calibration procedure is stored in
the analyzer. You can read these correction data using the remote control com-
mand
[SENSe<Ch>:]CORRection:CDATa
.
If external switch matrices are involved, use
[SENSe<Ch>:]CORRection:
SMATrix:CDATa
instead.
Step 1: Ports
Selects the calibrated analyzer ports, the cal unit characterization, the calibration type
and the power meter connection.
Background information
Refer to the following sections:
●
Chapter 4.5.7.2, "Calibration Types" , on page 173
●
Chapter 4.5.5.3, "Characterization of Calibration Units" , on page 163
Figure 5-16: SMARTerCal (Cal Unit), Step 1: Ports (> 4 Ports)
Cal Softtool