Rohde & Schwarz ZNB20, User Manual

Page: 474 / 1332

GUI Reference
R&S
®
ZNB/ZNBT
459 User Manual 1173.9163.02 ─ 38
Balanced Ports...
Opens a dialog to configure the logical ports of the analyzer.
See Chapter 5.9.1.3, "Balanced Ports Dialog" , on page 440.
5.9.7 Y-Z-Params Tab
Selects Y- and Z-parameters as measured quantities. Both the Y-parameters and the
Z-parameters can be used as an alternative to S-parameters in order to completely
characterize a linear n-port network.
Background information
Refer to the following sections:
●
Chapter 4.3.2, "Impedance Parameters" , on page 113
●
Chapter 4.3.3, "Admittance Parameters" , on page 116
●
Chapter 4.3.2.2, "Z-Parameters" , on page 115
●
Chapter 4.3.3.2, "Y-Parameters" , on page 117
Y/Z-Parameter
Selects an Y-parameter or Z-parameter as a measured quantity for the active trace.
For an n-port vector network analyzer, the pull-down list provides the full set of n 2 Y-
and Z-parameters.
Y- and Z-parameters are expressed as Y/Z
<out>< in>
, where <out> and <in> denote the
output and input port numbers of the DUT.
Remote command:
CALCulate<Ch>:PARameter:MEASure "<Trace_Name>", "Y11" |
"Z11" ...
Create new trace and select trace name and measurement parameter:
CALCulate<Ch>:PARameter:SDEFine "<Trace_Name>", "Y11" |
"Z11" ...
Meas Softtool