Rohde & Schwarz ZNB20, User Manual

Page: 879 / 1332

Command Reference
R&S
®
ZNB/ZNBT
864 User Manual 1173.9163.02 ─ 38
CONTrol:HANDler:PASSfail:SCOPe <Scope>
Specifies the "sweep end" condition that will cause the /PASS FAIL line (pin 33) to
report the status of the global limit check.
Note: This setting is not valid if the pass/fail mode is NOWait (
CONTrol:HANDler:
PASSfail:MODE NOWait
).
Parameters:
<Scope> GLOBal | CHANnel
CHANnel
–
when all the sweeps for each channel are complete
GLOBal
–
when all sweeps in all channels are complete
Note:
*RST
or "Preset" do not change the configuration of the
Universal Interface. Use
CONTrol:HANDler:RESet
to restore
default values.
*RST:
n/a (default: GLOBal)
Example: See
CONTrol:HANDler:PASSfail:MODE
CONTrol:HANDler:PASSfail:STATus?
Returns the global pass/fail status of the last measurement.
Return values:
<Status> PASS | FAIL | NONE
PASS
–
all measurements that are not in single sweep mode (on
hold) have been swept, and all limit checks have been passed.
FAIL
–
all measurements that are not in single sweep mode (on
hold) have been swept, at least one limit check failed according
to the specified pass/fail policy (
CONTrol:HANDler:
PASSfail:POLicy
).
NONE
–
no pass/fail status available, e.g. because the measure-
ment is in progress or because no limit check has been defined.
*RST:
n/a
Example: Preparations: Configure and enable a limit check. Start a mea-
surement and wait until the sweep is complete.
CONTrol:HANDler:PASSfail:STATus?
Query the result of the global limit check.
Usage: Query only
CONTrol:HANDler:RESet
Restores the default states of the
CONTrol:HANDler...
commands including the
data port values.
Example: See
CONTrol:HANDler[:EXTension]:INDex:STATe
Usage: Event
SCPI Command Reference