GUI Reference
R&S
®
ZNB/ZNBT
610
User Manual 1173.9163.02 ─ 38
Channel Bits Tab
Sets a channel-dependent eight-bit decimal value (0 ... 255) to control eight independ-
ent output signals at the USER PORT connector (lines 8 to 11 and 16 to 19).
Setting the channel bits does not change the analyzer state.
Channel Bits (Decimal)
Entry of the eight-bit decimal value (0 ... 255) for the selected channel. The channel
bits control eight output signals at the USER PORT connector. The signals are 3.3 V
TTL signals which can be used to differentiate between up to 256 independent ana-
lyzer states. For an application example refer to the description of the remote-control
command.
The decimal values have the following effect:
●
0 means that no output signals are enabled at any of the pins 8, 9, 10, 11 and 16,
17, 18, 19.
●
1 enables the output signal at pin 8. The signal is switched on while the R&S
ZNB/
ZNBT performs a measurement (sweep) in the selected channel. All other signals
are inactive.
●
2 enables the output signal at pin 9.
●
3 enables the output signals at pins 8 and 9.
●
...
●
255 enables the output signals at all pins. See also
Remote command:
Pin 16 - 19
Selects the control mechanism for the signals at pins 16 to 19 of the USER PORT con-
nector.
●
"Channel Bits":
Signals are controlled by channel bits 4 to 7. No drive port indica-
tion at the USER PORT connector.
●
"Drive Ports":
Signals indicate the active drive ports. The number of active chan-
nel bits is reduced to 4 (pins 8 to 11).
Remote command:
Advanced Tab
Collects several advanced settings.
Setup Softtool