Mazda MX-6 1998, Workshop Manual

Page: 1183 / 1282

SECURITY AND LOCKS
TRUNK LID STRIKER ADJUSTMENT
W 6 U 9 1 4 W 2 8
1. Verify that the trunk lid can be closed easily and 3. Tighten the trunk lid striker installation bolts,
that there is no looseness.
2. If not correct, loosen the trunk lid striker
installation bolts and move the striker horizontally
or vertically.
W6U914WAU
TRUNK LID STRIKER REMOVAL/INSTALLATION
1. Remove the trunk end trim. (Refer to 09-17
TRUNK END TRIM REMOVAL/INSTALLATION.)
2. Remove the bolts.
3. Remove the trunk lid striker.
IMMOBILIZER SYSTEM SERVICE CAUTION
Caution
•
When an immobilizer system component
(such as the PCM, immobilizer unit, coil or
the key) has failed, it must be accurately
determined according to the
troubleshooting procedures or by the
display of the diagnostic trouble codes
prior to carrying out the service
procedures.
W 6 U 9 1 4 W 3 0
• If a normal component is mistakenly
replaced and the ID number and/or code
word are input into the new component,
then neither component can be reused on
other vehicles.
W 6 U 9 1 4 W 2 9
4. Install in the reverse order of removal.
5. Adjust the trunk lid striker. (Refer to 09-14
TRUNK LID STRIKER ADJUSTMENT.)
0 9 -1 4 -1 5