Mazda MX-6 1998, Workshop Manual

Page: 1182 / 1282

SECURITY AND LOCKS
TRUNK LID LOCK ACTUATOR INSPECTION
Note
• The trunk lid lock actuator is built in the trunk
lid lock.
1. Disconnect the negative battery cable.
2. Open the trunk lid.
3. Disconnect the trunk lid lock actuator connector.
4. Apply battery positive voltage to the trunk lid lock
actuator terminals and check the operation of the
trunk lid lock actuator.
Terminal
Actuator operation
B+ GND
A
B U n lo c k
UNLOCK
— —
<A>J
W 6 U 9 1 4 W 2 5
W 6 U 9 1 4 W A Q
5. If not as specified, replace the trunk lid lock.
TRUNK LID OPENER SWITCH REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Disassemble the pocket. (Refer to 09-17 FRONT
DOOR TRIM DISASSEMBLY/ASSEMBLY.)
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
W 6 U 9 1 4 W 2 S
1
C o n n e c to r
2 P o c k e t b r a c k e t
3 S h o r t c o r d
4 T r u n k lid o p e n e r s w itc h
TRUNK LID OPENER SWITCH INSPECTION
1. Disconnect the negative battery cable.
2. Remove the trunk lid opener switch.
3. Check for continuity between the trunk lid opener
switch terminals by using an ohmmeter.
O O
: C o n t in u ity
Switch position
Terminal
A B
O ff
O n
O ---------------- -------------- O
W 6 U 9 1 4 W A S
W 6 U 9 1 4 W 2 7
(A )— o o — (B )
* B A
W6U914WAT
4. If not as specified, replace the trunk lid opener
switch.
0 9 -1 4 -1 4