Mazda MX-6 1998, Workshop Manual

Page: 824 / 1282

AUTOMATIC TRANSAXLE [LA4A-EL]
8. Carry out the road test. (Refer to 0 5 -1 7A ROAD
TEST [LA4A-EL].)
TURBINE SHAFT SPEED SENSOR REMOVAL/INSTALLATION [LA4A-EL]
1. Disconnect the negative battery cable.
2. Remove the wheel and tire, (drivers sheets side.)
3. Remove the splash shield.
4. Disconnect the turbine shaft speed sensor
connector.
5. Remove the turbine shaft speed sensor.
6. Apply ATF to a new O-ring and install it on a new
turbine shaft speed sensor.
7. Install the turbine shaft speed sensor.
W 6 U 5 1 7 W 4 6
Tightening torque
13 N m {1.3 kgf cm, 10 ft-lbf}
8. Connect the turbine shaft speed sensor
connector.
9. Install the splash shield.
10. Install the wheel and tire, (drivers sheets side)
11. Connect the negative battery cable.
TRANSAXLE FLUID TEMPERATURE SENSOR REMOVAL/INSTALLATION [LA4A-EL]
W 6 U 5 1 7 W 4 7
Note SOLENOID BODY REMOVAL/INSTALLATION
• Transaxle fluid temperature sensor (TFT) and [LA4A-EL] procedure,
solenoid valve are together as one unit, and
are installed to the solenoid body. Refer to the
O/D OFF INDICATOR LIGHT INSPECTION [LA4A-EL]
W 6 U 5 1 7 W 4 8
Refer to 05-17B O/D OFF INDICATOR LIGHT INSPECTION [GF4A-EL].
POWERTRAIN CONTROL MODULE INSPECTION [LA4A-EL]
W 6 U 5 1 7 W 3 7
Note
• For PID/DATA Monitor and Record, refer to
0 1 -4 0 A POWERTRAIN CONTROL MODULE
(PCM) INSPECTION [FS].
POWERTRAIN CONTROL MODULE REMOVAL/INSTALLATION [LA4A-EL]
W 6 U 5 1 7 W 3 8
Refer to 01-40A POWERTRAIN CONTROL
MODULE (PCM) REMOVAL/INSTALLATION [FS].
0 5 -1 7 A -1 9