Mazda MX-6 1998, Workshop Manual

Page: 1140 / 1282

DOORS AND LIFTGATE
REAR DOOR REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. To remove the checker, remove the rear door
screen. (Refer to 09 -1 4 REAR DOOR LOCK AND
OPENER REMOVAL/INSTALLATION.)
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
5. Adjust the rear door gap and height. (Refer to
09-11 REAR DOOR ADJUSTMENT.)
W 6 U 9 1 1 W 0 6
1 Connector
c r Removal Note
c r Installation Note
2 Checker pin
3 Door hinge
4 Rear door
5 Checker
8.9— 12.7 N m
{90— 130 k g fc m ,
79— 112 In lb f}
20— 30
{2.2—3.1,
16— 22}
Nm {kgfm, ftlbf}
W 6 U 9 1 1 W A 5
Connector Removal Note
1. Remove the rubber boot from the connector.
2. Pull out the green pin out until it stops.
3. Disconnect the connector.
Connector Installation Note
1. Push the green pin until it stops.
2. Install the rubber boot to the connector.
3. Connect the connector.
4. Repush the green pin until it stops for locking the
connector.
REAR DOOR WEATHERSTRIP REMOVAL/INSTALLATION
W 6 U 9 1 1 W 0 7
1. Remove the checker pin. 4. Install in the reverse order of removal.
2. Disengage the clips by using a fastener remover.
3. Remove the rear door weatherstrip.
C LIP B
W 6 U 9 1 1 W A 6
0 9 -1 1 -4