Mazda MX-6 1998, Workshop Manual, Page: 405 / 1282

MECHANICAL [FS]
Tension
____________________________________________N {kgf, Ibf}
Drive belt *New
Used L im it
Generator
736— 833
{75— 85,
165— 187}
491— 686
{50— 70,
110— 154}
392
{40, 88}
P/S
589— 784
{60— 80,
132— 176}
491— 686
{50— 70,
110— 154}
392
{40, 88}
P/S+A/C
687— 882
{70— 90,
154— 198}
491— 686
{50— 70,
110— 154}
441
{45, 99}
* : A belt that has been on a running engine for less than 5
minutes.
2. If the tension is not within the specification, adjust
it. (Refer to 0 1 -1 OA DRIVE BELT ADJUSTMENT
[FS].)
DRIVE BELT ADJUSTMENT [FS]
1. Loosen mounting bolts A and nut B.
2. Adjust the belt deflection or tension by turning the
adjusting bolt C. (Refer to 0 1 -1 OA DRIVE BELT
INSPECTION [FS].)
3. Tighten mounting bolts A and nut B.
P/S, P/S+A/C 44—60 A
{4 .4 — 6 .2 ,
3 2 — 44}
GENERATOR
A 1 9 — 2 5
{1 .9 — 2 .6 ,
14—18}
B 3 8 — 51
{ 3 .8 — 5 .3 , 2 8 — 38}
A/C
COMPRESSOR
PULLEY
N m { k g f m , f t l b f }
W 6 U 1 1 0 W A 4
4. Verify the belt deflection or tension. (Refer to
01-10A DRIVE BELT INSPECTION [FS].)
3 8 — 51
{ 3 .8 — 5 .3 , 2 8 — 3 8 }
A
Nm {kgf-m, ftlbf}
W 6 U 1 1 0 W A 3
VALVE CLEARANCE INSPECTION [FS]
W 6 U 1 1 0 W 0 3
1. Remove the cylinder head cover. (2) Measure the valve clearance at A in the figure.
2. Verify that the engine is in cold condition.
3. Measure the valve clearance. Standard [Engine cold]
(1) Turn the crankshaft clockwise so that the No.1 0.225— 0.295 mm {0.0089— 0.0116 in}
piston is at TDC of the compression stroke.
IN
EX
0 1 -1 OA-2