Mazda MX-6 1998, Workshop Manual

Page: 855 / 1282

AUTOMATIC TRANSAXLE [GF4A-EL]
INPUT/TURBINE SPEED SENSOR REMOVAL/INSTALLATION [GF4A-EL]
1. Disconnect the negative battery cable.
2. Remove the resonance chamber, fresh-air duct,
and air cleaner component. (Refer to 0 1 -1 3B
INTAKE-AIR SYSTEM
REMOVAL/INSTALLATION [KL].)
3. Remove the fuel filter mounting nuts.
4. Disconnect the input/turbine speed sensor
connector.
5. Remove the input/turbine speed sensor.
W6U517W23
6. Apply ATF to a new O-ring and install it on a new
input/turbine speed sensor.
7. Install the input/turbine speed sensor.
Tightening torque
7.9— 10.7 N m
(80— 110 kgf-cm, 69.5— 95.4 in lbf}
8. Connect the input/turbine speed sensor connector.
9. Install the fuel filter mounting nuts.
10. Install the air cleaner component, fresh-air duct,
and resonance chamber. (Refer to 0 1 -1 3B
INTAKE-AIR SYSTEM
REMOVAL/INSTALLATION [KL].)
11. Connect the negative battery cable.
VEHICLE SPEEDOMETER SENSOR INSPECTION [GF4A-EL]
1. Remove the vehicle speedometer sensor. (Refer
to 05-17B VEHICLE SPEEDOMETER SENSOR
REMOVAL/INSTALLATION [GF4A-EL].)
W6U517W24
W6U517WDH
3. Install the vehicle speedometer sensor. (Refer to
05-17B VEHICLE SPEEDOMETER SENSOR
REMOVAL/INSTALLATION [GF4A-EL].)
W6U517WDG
2. Measure the voltage between terminals of the
vehicle speedometer sensor while rotating the
driven gear.
Meter needle Action
Moves slightly under 5 V
Repair wiring harness
(Instrument cluster— Vehicle
speedometer sensor)
Does not move
Replace vehicle speedometer
sensor
0 5 -1 7 B -1 5