TROUBLESHOOTING [IMMOBILIZER SYSTEM]
DTC
P1622
Key ID number does not match
DESCRIPTION
* ID number stored in immobilizer unit (IU) and PCM does not match. This DTC is indicated only after
immobilizer unit is replaced and reprogramming system.
[Possible Cause]
• Unregistered key is used in step 3 of immobilizer system
• Transformation of key ID number stored in PCM.
reprogram procedure (IU replacement).
STEP
INSPECTION
ACTION
1
CHECK DTC PRESENT
• RESET PCM to completely clear DTCs.
a-
After Repair Procedure
• RERUN OBD test.
• Is same DTC present after cranking?
Yes
Go to next step.
No
Different DTC displayed:
Go to appropriate DTC inspection.
No DTC displayed:
Troubleshooting is completed.
2
CHECK ENGINE IS STARTING NORMALLY
USING ANOTHER REGISTERED KEY
• Does engine start with another registered
key?
Yes
Previous key is defective. Discard it.
No
Replace PCM and reprogram immobilizer system,
r r 0 9 -1 4 IMMOBILIZER SYSTEM REPROGRAMMING
PROCEDURE, PCM Replacement
DTC
P1623
Code word or key ID number write/read error in PCM
DESCRIPTION
• PCM internal EEPROM damaged
[Possible Cause]
• PCM internal EEPROM damaged
STEP
INSPECTION
ACTION
1
CHECK DTC PRESENT
• RESET PCM to completely clear DTCs.
tr
After Repair Procedure
• RERUN OBD test.
• Is same DTC present after cranking?
Yes
Replace PCM and reprogram immobilizer system.
o - 0 9 -1 4 IMMOBILIZER SYSTEM REPROGRAMMING
PROCEDURE, PCM Replacement
No
Different DTC displayed:
Go to appropriate DTC inspection.
No DTC displayed:
Troubleshooting is completed.
DTC
P1624
Immobilizer system communication counter
=
0
DESCRIPTION
• PCM detected immobilizer system malfunction more than three times.
[Possible Cause]
• Engine was attempted to start more than three times
under malfunction.
•s
STEP
INSPECTION
ACTION
1
CHECK DTC P1624 PRESENT
• RESET PCM to completely clear. DTCs
c r After Repair Procedure
• RERUN OBD test.
• Is P1624 still present after cranking?
Yes
Go to next step.
No
Troubleshooting is completed.
2
CHECK DTC PRESENT
Yes
Go to other DTC inspection.
• Is there another DTC.
No
Go to ENGINE SYMPTOM TROUBLESHOOTING No.5.
0 9 -0 1 F -8
Summary of Contents for MX-6 1998
