Mazda MX-6 1998, Workshop Manual

Page: 437 / 1282

MECHANICAL [KL]
REAR OIL SEAL REPLACEMENT [KL]
W6U110W20
1. Remove the flywheel. (MTX) (Refer to 05-10 Rear Oil Seal Removal Note
CLUTCH UNIT REMOVAL/INSTALLATION.) 1. Cut the oil seal lip by using a razor knife.
2. Remove the drive plate. (ATX) (Refer to 0 5 -1 7B 2. Remove the oil seal by using a screwdriver
DRIVE PLATE REMOVAL/INSTALLATION protected w*h a rag.
[GF4A-EL].)
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
W6U110WDN
Rear oil seal
i d
-
Removal Note
ir 7 Installation Note
Rear Oil Seal Installation Note
1. Apply clean engine oil to the new oil seal lip.
2. Push the oil seal slightly in by hand.
3. Tap the oil seal in evenly by using the
SST and a
hammer.
W6U110WDP
0 1 -1 O B -16