Mazda MX-6 1998, Workshop Manual

Page: 649 / 1282

CONVENTIONAL BRAKE SYSTEM
FLUID LEVEL SENSOR INSPECTION
1. Disconnect the sensor connector.
2. Connect an ohmmeter to the connector.
3. Starting with the fluid level above MIN, verify that
there is no continuity.
4. Remove the brake fluid and verify that there is
continuity when the level is below MIN.
O O : Continuity
F lu id level
Term inal
A B
Below MIN
O--------- ---------O
Above MIN
W 6 U 4 1 1 W 0 7
5. If not as specified, replace the sensor.
W 6 U 4 1 1 W A M
W 6 U 4 1 1 W A L
MASTER CYLINDER DISASSEMBLY/ASSEMBLY
W 6 U 4 1 1 W 0 8
Caution
•
If the master cylinder body is damaged, replace the unit as an assembly. When securing the
master cylinder in a vise, tighten only the flange of the master cylinder. Tightening other places
on master cylinder will cause damage to the cylinder body.
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
1 Cap set
2 Float
3 Screw
4 Reservoir
5
Joint bushing
6
Fluid level sensor
7 Snap ring
8 Spacer
9 Piston guide
10 O-ring
11 Cup
12 Primary piston stopper
13 Primary piston
14 Stop screw (without ABS)
tr Assembly Note
0 4 -1 1 -8