Mazda MX-6 1998, Workshop Manual

Page: 505 / 1282

CRUISE CONTROL SYSTEM
5. Press the hooks of the grommet, and remove it
from the dash lower panel.
6. Push the actuator cable through the dash lower
panel to remove it.
7. Install In the reverse order of removal.
8. Adjust the actuator cable. (Refer to 01-20
ACTUATOR CABLE ADJUSTMENT.)
CRUISE CONTROL SWITCH REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the driver-side air bag module. (Refer to
0 8 -1 0 DRIVER-SIDE AIR BAG MODULE
REMOVAL/INSTALLATION.)
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
W 6 U 1 2 0 W 0 5
1 Connector
2
Screw
3 Cruise control switch
W6U120WAC
CRUISE CONTROL SWITCH INSPECTION
1. Disconnect the negative battery cable.
2. Remove the driver-side air bag module. (Refer to
08-10 DRIVER-SIDE AIR BAG MODULE
REMOVAL/INSTALLATION.)
3. Disconnect the cruise control switch connector.
4. Measure the resistance and check for continuity
between the cruise control switch terminals by
using an ohmmeter.
: Continuity O W V O : Resistance
Switch position
Terminal
A
B
C
CRUISE MAIN
switch hold at on
OFF switch hold at
on
U
SET/COAST
switch hold at on
O — M
/V — O Ri
RESUME/ACCEL
switch hold at on
O — — O R
2
Other
M A IN S W IT C H
C R U IS E
\
MAIN i
_________________ J
C O N T R O L S W IT C H
i R E S U M E /A C C E L ~ j
r ^ o - W n l
l
-
o
^
o
-
w
- T T
S E T /C O A S T I
I_________ I
c c
W 6 U 1 2 0 W 0 6
JSL.
a
:
W6U120WAE
5. If not as specified, replace the cruise control
switch.
R ! : approx. 240 i i R2: approx. 910 Q
W 6 U 1 2 0 W A D
0 1 -2 0 -4