Mazda MX-6 1998, Workshop Manual, Page: 609 / 1282

DRIVE SHAFT
Engine Mounting Member Removal Note
Caution
• To prevent damage to the body, insert a
rag into the gap between the fender and
body, when installing the SST.
• Suspend the engine by using the SST and remove
the engine mounting member.
49 G 01 7
Note
• If the drive shaft will not come out of the front
wheel hub easily, install an already discarded
nut onto the drive shaft so that the nut is flush
with the end of the drive shaft. Tap the nut
with a copper hammer to loosen the drive
shaft from the front wheel hub.
Drive Shaft Removal Note
Caution
•
The sharp edges of the drive shaft can
slice or puncture the oil seal. Be careful
when removing the drive shaft from the
transaxle.
1. Separate the left side drive shaft from the
transaxle by prying with a bar inserted between
the outer ring and the transaxle, as shown in the
figure.
2. In sta ll th e
SST
in to th e tra n s a x le to hold th e side
gears.
Drive Shaft Installation Note
Caution
•
The sharp edges of the drive shaft can
slice or puncture the oil seal. Be careful
when installing the drive shaft to the
transaxle.
W 6 U 3 1 3 W A K
W 6 U 3 1 3 W A P
W 6 U 3 1 3 W A M
3. Separate the right side drive shaft from the joint
shaft by hammering on a bar inserted between
them.
Caution
•
The oil seals are damaged easily if this
procedure is not done correctly.
3. Push the drive shaft into the transaxle (left side) or
joint shaft (right side).
2. Apply grease to the ends of the drive shafts.
1. Turn the clip with the opening facing upward.
30.5 mm {1.2 in}
W 6 U 3 1 3 W A Q
0 3 -1 3 -7