Mazda MX-6 1998, Workshop Manual

Page: 869 / 1282

AUTOMATIC TRANSAXLE [GF4A-EL]
Oil Pipe Installation Note
Note
• In order to prevent ATF leakage, replace the
hose. When any damages are found inside or
outside of the hose, especially on areas
contacting with pipes.
• Apply compressed air to the cooler-side pipe
opening, and blow any remaining dust and foreign
material from the cooler pipes. Compressed air
should be applied for no less than one minute.
Transaxle side
1. Position the marking on the oil hose side facing up
and install it.
M A R K
CONTROL VALVE / /
BODY COVER i S
W 6 U 5 1 7 W E Y
2. Aligen the marks, and slide the oil hose onto oil
pipe until it is full seated as shown.
Oil Hose Installation Note
Oil cooler side
1. Position the marking on the oil hose side facing up
and install it.
MARK
W 6 U 5 1 7 W E X
2. Position the marking on the oil hose side facing to
the radiator and install it.
W 6 U 5 1 7 W E Z
Hose Clamp Installation Note
1. Install the hose clamp onto the hose. If reusing
the hose, install the new hose clamp exactly into
the mark left by the previous hose clamp.
W 6 U 5 1 7 W F 0
2. Verify that the hose clamp does not interfere with
any other parts.
OIL COOLER
OIL COOLER
W6U517WF6
0 5 -1 7 B -2 9