Mazda MX-6 1998, Workshop Manual

Page: 793 / 1282

CLUTCH
Clutch Cover and Disc Removal Note
1 . Install the SST.
Flywheel Installation Note
1. Install the flywheel to the crankshaft.
2. When reusing the bolts, clean and apply sealant
to the threads. (FS)
WSU510WA9
2. Loosen each bolt one turn at a time in a crisscross
pattern until spring tension is released.
3. Remove the clutch cover and disc.
Pilot Bearing Removal Note
Note
• The pilot bearing does not need to be
removed unless you are replacing it.
• Use the SST to remove the pilot bearing.
Note
• FS: 6 bolt
• KL: 8 bolt
Pilot Bearing Installation Note
• Install a new pilot bearing by using a SST.
Bearing installation depth
0— 0.4 mm {0— 0.015 in}
W 6 U 5 1 0 W A A
Flywheel Removal Note
1. Hold the flywheel by using the SST.
2. Remove the bolts evenly and gradually in a
crisscross pattern.
Note
• FS: 6 bolt
• KL: 8 bolt
W6U510WAP
3. Remove the flywheel.
W6U510WAB
W6U510WAC
5. Gradually tighten the flywheel lock bolts in a
crisscross pattern.
Note
• No sealant is needed when using new bolts.
(FS)
3. Hand-tighten the flywheel lock bolts.
4. Install the SST to the flywheel.
Clutch Disc Installation Note
• Hold the clutch disc position by using the SST.
W6U510WAD
0 5 -1 0 -8