Mazda MX-6 1998, Workshop Manual

Page: 823 / 1282

AUTOMATIC TRANSAXLE [LA4A-EL]
VEHICLE SPEEDOMETER SENSOR REMOVAL/INSTALLATION [LA4A-EL]
W 6 U 5 1 7 W 4 4
6. Apply ATF to a new O-ring and install it on a new
vehicle speedometer sensor.
7. Install the vehicle speedometer sensor.
1. Disconnect the negative battery cable.
2. Remove the battery component. (Refer to 01-17
BATTERY REMOVAL/INSTALLATION.)
3. Remove the air cleaner component. (Refer to
01-13A INTAKE-AIR SYSTEM
REMOVAL/INSTALLATION [FS].)
4. Disconnect the vehicle speedometer sensor
connector.
5. Remove the vehicle speedometer sensor.
Tightening torque
5— 6 N-m {50— 61 kgf-cm, 44— 53 in-lbf)
8. Connect the vehicle speedometer sensor
connector.
9. Install the battery component. (Refer to 01-17
BATTERY REMOVAL/INSTALLATION.)
10. Install the air cleaner component. (Refer to
01-13A INTAKE-AIR SYSTEM
REMOVAL/INSTALLATION [FS].)
11. Connect the negative battery cable.
W 6 U 5 1 7 W F A
SOLENOID BODY REMOVAL/INSTALLATION [LA4A-EL]
1. Remove the control valve body. (Refer to 0 5 -1 7A
CONTROL VALVE BODY AND TERMOSTATIC
OIL LEVEL CONTROL VALVE
REMOVAL/INSTALLATION [LA4A-EL].)
2. Remove the solenoid body component.
W 6 U 5 1 7 W 4 5
3. Remove the solenoid gasket from the accumulator
body. Discard the solenoid gasket.
SOLENOID GASKET
W 6 U 5 1 7 W F D
4. Install the solenoid body and a new gasket on the
accumulator body.
Note
• Match the solenoid body gasket to the
passages.
5. Install the bolts.
Tightening torque
10 N-m {1.1 kgf-m, 7 ft lbf}
SOLENOID BODY-TO-ACCUMULATOR BODY
BOLTS (2)
W 6 U 5 1 7 W F F
6. Install the control valve body. (Refer to 0 5 -1 7A
CONTROL VALVE BODY AND TERMOSTATIC
OIL LEVEL CONTROL VALVE
REMOVAL/INSTALLATION [LA4A-EL].)
7. Carry out the time lag test and line pressure test.
(Refer to 0 5 -1 7A MECHANICAL SYSTEM TEST
[LA4A-EL], Line Pressure Test.)
0 5 -1 7 A -1 8