
MECHANICAL [KL]
W 6 U 1 1 0 W D 9
11. Tap in the new blind cap by using a plastic
hammer.
W 6 U 1 1 0 W D A
Camshaft Pulley Installation Note
1. Install the camshaft pulley so that the “ R” mark
(RH) can be seen and the timing mark aligns with
the camshaft knock pin.
2. Install the camshaft pulley so that the “L” mark
(LH)
can be seen and the timing mark aligns with
the camshaft knock pin.
W 6 U 1 1 0 W D C
Cylinder Head Cover Installation Note
1. Verify that the grooves on the cylinder head cover
are free of oil, water and other foreign material.
2.
Install the new cylinder head cover gasket into the
cylinder head cover.
3. Apply silicone sealant to the shaded areas as
shown.
Thickness
01.5— 2.5 mm {0.060— 0.098 in}
4. Install the cylinder head cover and tighten the
bolts gradually in two or three steps in the order
shown.
HAMMER
CYLINDER HEAD
mm
{0— 0.019 in}
E3
OIL SEAL
3.
Hold the camshaft by using a wrench on the cast
hexagon as shown, and tighten each bolt.
Tightening torque
123— 140 N m
{12.5— 14.3 kgf-m, 91— 103 ft lbf}
W 6 U 1 1 0 W D D
S^OTII
h
^222E||
W 6 U 1 1 0 W D F
B | S ) |
W6U110WDG
0 1 -1 0 B -1 4
Summary of Contents for MX-6 1998
