Mazda MX-6 1998, Workshop Manual

Page: 574 / 1282

SUSPENSION
02
SECTION
GENERAL PROCEDURES . . . . 02-10
REAR SUSPENSION........ . . . . 02-14
WHEEL ALIGNMENT .............
02-11 TECHNICAL D A TA ............ . . . . 02-50
FRONT SUSPENSION.............. 02-13
SERVICE T O O L S .............. 02-60
02-10 GENERAL PROCEDURES
PRECAUTION (S U S P E N S IO N )................ 02-10-1
PRECAUTION (SUSPENSION)
Wheels and tires removal/installation
• The removal and installation procedures for the
wheels and tires are not mentioned In this section.
When a wheel is removed, retighten it to
90— 110
N m (9— 12 kgf-m, 66— 86 ft lbf}.
Suspension links removal/installation
• Tighten any part of the suspension that uses
rubber bushings only after the vehicle has been
lowered and unloaded.
W 6 U 2 1 0 W 0 1
Note
• Unloaded ... Fuel tank full; engine coolant and
engine oil at specified levels; spare tire, jack
and tools in designated position.
Power steering components removal/installation
• If any power steering fluid line has been
disconnected anytime during the procedure, add
ATF M -III or equivalent (e.g. Dexron®II), bleed
the fluid line, and inspect for leakage after the
procedure has been completed.
0 2 -1 0 -1