Mazda MX-6 1998, Workshop Manual

Page: 941 / 1282

CONTROL SYSTEM
1 Connector
2 Screw
3 Resistor
RESISTOR INSPECTION
1. Remove the under cover.
2. Disconnect the resistor connector.
3. Check for continuity between the terminal C and E
of the resistor.
4. Verify that the resistance between the terminals of
the resistor is as shown in the table.
Terminal Resistance (ft)
C— F
0.25— 0.31
C— B 0.83— 0.97
C— A 2.21— 2.59
W 6 U 7 4 0 W 2 8
E C A
F
*
B
W 6 U 7 4 0 W B 7
5. If not as specified, replace the resistor.
MAGNETIC CLUTCH DISASSEMBLY/ASSEMBLY
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
3. Adjust the magnetic clutch clearance. (Refer to
0 7 -4 0 MAGNETIC CLUTCH ADJUSTMENT.)
W6U740WA6
1 Nut
zr Removal/Installation Note
2 Pressure plate
3 Shim
4 Snap ring
5 A/C compressor pulley
c r Removal Note
6
Snap ring
W 6 U 7 4 0 W 0 4
7
Screw
8 Clip
9 Stator
Nut Removal/Installation Note
• When removing or installing the nut, hold the
pressure plate in place as shown in the figure.
A/C Compressor Pulley Removal Note
• When removing the A/C compressor pulley,
remove it by using a puller.
0 7 -4 0 -9