Mazda MX-6 1998, Workshop Manual

Page: 394 / 1282

TROUBLESHOOTING [CRUISE CONTROL SYSTEM]
STEP
INSPECTION
ACTION
22
Hold SET/COAST switch to on position.
Measure resistance between terminal E
(cruise control switch position signal) and F
(cruise control switch position signal) of cruise
actuator.
Is resistance at 228 to 252 i2?
W 6 U 1 0 1 W P 7
Yes
Go to step 25.
No Go to next step.
23*
Disconnect clock spring connectors (4-pins).
Hold SET/COAST switch to on position.
Measure resistance between terminal A
(cruise control switch position signal) and B
(cruise control switch position signal) of clock
spring.
Is resistance at 228 to 252 i2?
Yes Repair wiring harness from cruise actuator to clock spring,
then go to step 37.
No Go to next step.
24 Inspect cruise control switch.
zr 0 1 -2 0 CRUISE CONTROL SWITCH
INSPECTION
Is it okay?
Yes Repair short cord on clock spring: connected to cruise
actuator or cruise control switch, then go to step 37.
No Replace cruise control switch, then go to step 37.
25* Measure voltage at terminal C (ignition 1
signal) of clock spring (4-pin) connector.
Is voltage 12 V?
Yes Go to step 28.
No Go to next step.
0 1 -0 1 C -6