Mazda MX-6 1998, Workshop Manual

Page: 494 / 1282

CHARGING SYSTEM
GENERATOR REMOVAL/INSTALLATION
Warning
• When the battery cables are connected,
touching the vehicle body with generator
terminal B will generate sparks. This can
cause personal injury, fire, and damage to
the electrical components. Always
disconnect the battery before performing
the following operation.
1. Disconnect the negative battery cable.
2. Remove the transverse member. (FS)
3. Remove the front pipe. (FS) (Refer to 01-15
EXHAUST SYSTEM REMOVAL/INSTALLATION
[FS].)
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. Verify the drive belt deflection/tension. (Refer to
01-10A DRIVE BELT INSPECTION [FS].) (Refer
to 01-1 OB DRIVE BELT INSPECTION [KL].)
FS
W 6 U 1 1 7 W 0 4
W 6 U 1 1 7 W A 3
9.9— 14.7 N m
{100— 150 k g fc m , 87— 130 in lb f)
38— 51 {3.8— 5.3,28— 38}
19—25(1.9—2.6,14— 18}
N m {kgf-m, ft-lbf}
W 6 U 1 1 7 W A 2
1 Terminal B wire
2 Connector
3 Drive belt
4 A/C compressor [KL]
cr Removal Note
5 Generator
A/C Compressor Removal Note [KL]
• Remove the A/C compressor with the pipe still
connected. Position the A/C compressor so that it
is out of the way.
0 1 -1 7 -3