Mazda MX-6 1998, Workshop Manual

Page: 830 / 1282

AUTOMATIC TRANSAXLE [LA4A-EL]
ENGINE
MOUNT
MEMBER
W6U517WF8
W 6 U 5 1 7 W E F
2. Verify that there is no damage to the oil seal.
3. Hand tighten A bolts.
4. Tighten the A, B bolts to the specified torque.
Tightening torque
43— 61 N-m {4.3— 6.3 kgf-m, 32— 45 ftlb f}
3. Install the clip.
Tie Rod End Installation Note
1. Install the locknut.
Tightening torque
32—44 N-m {3.2—4.5 kgf-m, 24— 32 ft lbf}
W 6 U 5 1 7 W 8 B
2. Install the ABS wheel speed sensor harness
mounting nuts.
Tightening torque
7.9— 10.7 N-m
{80— 110 kgf-cm, 69.5— 95.4 in-lbf}
W 6 U 5 1 7 W F B
W 6 U 5 1 7 W B D
Drive Shaft Installation Note
Refer to 0 3 -1 3 JOINT SHAFT
REMOVAL/INSTALLATION, Clip Installation Note.
Lower Arm Installation Note
1. Connect the lower arm to the knuckle and tighten
the clinch bolt.
Tightening torque
37— 53 N-m {3.7— 5.5 kgf-m, 27— 39 ft lbf}
2. Secure the locknut by using a new cotter pin.
No.2 Engine Mount, Engine Mount Member
Installation Note
1. Position the direction indicator on engine mount
member bushings facing toward the front side,
and install the bushings onto the engine mount
member.
D
FRONT
DIRECTION
INDICATOR
BUSHING
W 6 U 5 1 7 W B C
0 5 -1 7 A -2 5