AUTOMATIC TRANSAXLE [LA4A-EL]
Radiator Installation Note
1. The automatic transaxle oil cooler flushing must
be performed whenever a transaxle is removed for
service to remove existing fluid which may be
contaminated and to prevent contamination of
new fluid. The flushing must be performed after
installation of the overhauled replacement of the
transaxle.
2. Follow the instruction in the manufacture’s
publication for flushing the automatic transaxle oil
cooler.
Oil Pipe Installation Note
Oil Hose Installation Note
Radiator side
•
Align the marks, and slide the oil hose onto the oil
pipe until it is fully seated as shown.
MARKS
Note
•
In order to prevent ATF leakage, replace the
hose. When any damages are found inside or
outside of the hose, especially on areas
contacting with pipes.
Apply compressed air to the cooler-side pipe
opening, and blow any remaining dust and foreign
material from the cooler pipes. Compressed air
should be applied for no less than one minute.
W 6 U 5 1 7 W C K
Transaxle side
•
Position the marking on the oil hose side facing up
and install it.
O IL PIPE
W 6 U 5 1 7 W C L
Hose Clamp Installation Note
•
Install the hose clamp onto the hose. If reusing
the hose, install the new hose clamp exactly into
the mark left by the previous hose clamp.
W 6 U 5 1 7 W C M
0 5 -1 7 A -3 4
Summary of Contents for MX-6 1998
