Mazda MX-6 1998, Workshop Manual, Page: 1243 / 1282

WIPER/WASHER SYSTEMS
WINDSHIELD WASHER MOTOR INSPECTION
1. Partially peel off the right side mud guard.
2. Remove the windshield washer tank.
3. Connect battery positive voltage to terminal B and
ground to terminal A of the motor.
4. Verify that the windshield washer motor operates.
W 6 U 9 1 9 W 0 8
5. If the motor does not operate, replace the
windshield washer motor.
_ a_
W 6 U 9 1 9 W A C
WASHER FLUID-LEVEL SENSOR REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Partially peel off the right side mud guard.
3. Remove the windshield washer tank.
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
W 6 U 9 1 9 W 0 9
Washer fluid-level sensor
Grommet
W 6 U 9 1 9 W A D
WASHER FLUID-LEVEL SENSOR INSPECTION
1. Partially peel off the right side mud guard.
2. Remove the windshield washer tank.
3. Inspect for continuity between the washer
fluid-level sensor terminals by using an ohmmeter.
O Q : Continuity
Fluid level
Terminal
A B
Above Low
Below Low 0 ----------- ----------- O
W 6 U 9 1 9 W A E
W 6 U 9 1 9 W 1 0
J
------- N
r
B A
u
W 6 U 9 1 9 W A F
4. If not as specified, replace the washer fluid-level
sensor.
0 9 -1 9 -5