Mazda MX-6 1998, Workshop Manual, Page: 1263 / 1282

INSTRUMENTATION/DRIVER INFO.
DTC 26 LCD indication
INSPECTION INDICATION SITUATION
ACTION
Wait for 2 seconds after selecting DTC
26.
n n n n n n
u u u u u u
i i i i i i
i i i i i i
□ o □ □ □ □
□ □ □ □ □ □
n n n n □ o
□ □ d u u □
W 6 U 9 2 2 W B Q
(Display the number
sequentially from 1 to 9
and all segment are
displayed)
Indication is normal.
LCD is okay.
Other than above stated.
Replace the display unit
assembly.
WARNING AND INDICATOR LIGHT BULB REMOVAL/INSTALLATION
W 6 U 9 2 2 W 0 4
1. Disconnect the negative battery cable.
2. Remove the meter hood. (Refer to 09-17 METER
HOOD REMOVAL/INSTALLATION.)
3. Remove the instrument cluster. (Refer to 09-22
INSTRUMENT CLUSTER
REMOVAL/INSTALLATION.)
4. Turn the socket counterclockwise to remove the
bulb as shown in the figure.
5. Install in the reverse order of removal.
FUEL GAUGE SENDER UNIT INSPECTION
1. Remove the fuel pump. (Refer to 01-14 FUEL
PUMP REMOVAL/INSTALLATION.)
2. Using an ohmmeter, measure and verify that the
resistance between terminal A and terminal D of
the fuel gauge sender unit terminals as shown in
the following chart while slowly moving the unit
arm from empty to full.
W 6 U 9 2 2 W 0 5
Measuring point Resistance (Q)
Full
2.4— 6.4
1/2
5 2 - 5 8
Empty
103.3— 107.3
3. If not as specified, replace the fuel gauge sender
unit. (Refer to 01-14 FUEL PUMP
REMOVAL/INSTALLATION.)
B U LB
W 6 U 9 2 2 W A 2
- 5 . 0 — 5 . 0
{ - 1 . 9 — 1 . 9 }
EMPTY
mm {In}
W6U922WA3
1 1 3 .0 -1 2 3 .0
{44.49— 48.42}
0 9 -2 2 -6