Mazda MX-6 1998, Workshop Manual

Page: 875 / 1282

AUTOMATIC TRANSAXLE SHIFT MECHANISM
6. Press the lock piece in until it is locked.
LOCK PIECE
INTERLOCK CABLE
UNLOCK CONDITION LOCK CONDITION
W 6 U 5 1 8 W A F
7. Remove the lock unit lock pin in the order shown
in the figure.
2. Install the selector cable to the cable bracket.
3. Install the clip to the selector cable.
4. Connect the selector cable to the manual shaft
lever on the transaxle.
W 6 U 5 1 8 W A J
Selector Lever Installation Note
1. Install the selector lever.
2. Install the selector cable to the selector lever.
Tightening torque
16— 22 N m {1.6— 2.3 kgf-m, 12— 16 ft-lbf}
3. Shift the selector lever to P position (KL), or D
range (FS).
4. Connect the set button.
5. Slide the lock cover and lock the set button.
W 6 U 5 1 8 W A K
Selector Cable Installation Note
1. Shift the selector lever and manual shaft to P
position (KL), or D range (FS).
Caution
•
Bending the selector cable in the manner
shown in the figure will damage the cable
and cause it to become loose during
shifting, when handling and installing the
selector cable, hold it straight.
Indicator Panel installation Note
1. Shift the selector lever to P position.
2. Align the alignment screws in the slider with the
holes in the indicator panel. Install heavy-gauge
wire to hold the slider.
W 6 U 5 1 8 W A L
W 6 U 5 1 8 W A H
3. Tighten the indicator panel screws in the order
shown in the figure.
Tightening torque
2.0— 2.9 N m {20—30 kgf cm, 18— 26 in lbf}
0 5 -1 8 -5