TROUBLESHOOTING [AIR BAG SYSTEM]
STEP
INSPECTION
ACTION
9*
Disconnect SAS unit connector (21-pin) and
instrument cluster connector (12-pin).
Check for continuity between terminal Q at
SAS unit connector (21-pin) of wiring harness
and terminal 11 at instrument cluster connector
(12-pin) of wiring harness.
Is there continuity?
W 6 U 8 0 1 W A V
Yes
Replace SAS unit, then go to step 10.
o r 0 8 -1 0 SAS UNIT REMOVAL/INSTALLATION
No
Replace or repair wiring harness between instrument
cluster and SAS unit, then go to step 10.
10
Connect SAS unit connector.
Connect instrument cluster connector.
Connect negative battery cable.
When turning ignition switch to ON, does air
bag system warning light operate properly?
Yes
Troubleshooting completed.
No
Reconfirm symptoms of malfunction.
Air bag system warning light illuminates immediately after ignition switch is turned to ON and remains
illuminated
TROUBLESHOOTING HINTS
Malfunction in air bag system warning light circuit
© A ir bag system warning light remains illuminated
SAS unit malfunction
Malfunction in short bar between terminal Q of SAS unit connector (21-pin) and terminal S of SAS unit connector
(21-pin)
Battery malfunction or battery charge/discharge system malfunction
Poor connection of SAS unit connector (21-pin)
Malfunction in wiring harness between instrument cluster and SAS unit
STEP
INSPECTION
ACTION
Measure battery positive voltage.
Is voltage
more than 9 V?
Yes
Go to next step.
No
Inspect engine charging system.
tr
01-01 ENGINE SYMPTOM TROUBLESHOOTING
Turn ignition switch to LOCK.
Disconnect negative battery cable and wait for
more than 1 minute
to allow the backup
power supply of SAS unit to deplete its stored
power.
Remove rear console.
C 7 -
0 9 -1 7 REAR CONSOLE
REMOVAL/INSTALLATION
Remove the driver-side side wall.
Is terminal Q of SAS unit connector (21-pin)
securely connected with connector?
Yes
Go to next step.
No
Reconnect properly, then go to step 6.
W6U801WAQ
0 8 -0 1 A - 1 2
Summary of Contents for MX-6 1998
