DRIVE SHAFT
Joint Shaft Assembly Note
•
Assemble the joint shaft by using a press and the
SST.
2. Press in the dust cover to the marked position by
using a steel plate and the
SST.
3. Verify that length L is within the specification.
W 6 U 3 1 3 W A E
■
r
W 6 U 3 1 3 W A G
Dust Cover Assembly Note
1. Mark the shaft as shown in the figure.
Length L
88.5— 89.5 mm {3.49— 3.52 in}
W 6 U 3 1 3 W A F
DRIVE SHAFT PREINSPECTION
1. Inspect the dust boot on the drive shaft for cracks,
damage, leaking grease, and a loose boot band.
2. Inspect the drive shaft for bending, cracks, and
wear of joints or splines.
3. Repair or replace the drive shaft as necessary.
W 6 U 3 1 3 W 0 4
W 6 U 3 1 3 W A H
0 3 -1 3 -5
Summary of Contents for MX-6 1998
