Mazda MX-6 1998, Workshop Manual

Page: 1178 / 1282

SECURITY AND LOCKS
TRANSMITTER DISASSEMBLY/ASSEMBLY
1. Remove the cover by using a quarter coin.
2. Remove the battery.
Battery specification
Lithium CR 2032 x 1
BATTERY
W 6 U 9 1 4 W A G
TRANSMITTER INSPECTION
Note
• It the battery is not subject to load it cannot be
properly inspected.
• A correct measurement cannot be obtained
when the battery temperature is low. If the
inspection result is below the standard
voltage, inspect it again after it has been at 18
°C {64 °F} or more for at least 30 minutes.
• There is an auto power off function in the
transmitter, so be sure to read the voltage
within 0.5 seconds after pushing the button.
• If the transmitter is malfunctioning, the battery
cannot be properly inspected.
1. Remove the transmitter cover.
2. Connect the positive (+) lead of the voltmeter to
the positive (+) terminal of the transmitter and the
negative (-) lead to the circuit element.
W 6 U 9 1 4 W 1 7
3. Assemble in the reverse order of disassembly.
Note
• The battery will last about 2 years when used
10 times a day.
W 6 U 9 1 4 W 1 8
POSITIVE (+) LEAD
NEGATIVE (-) LEAD
W 6 U 9 1 4 W D 1
3. Push any button of transmitter 10 times or more in
every 1 second and measure the voltage every
time.
4. Compare the minimum voltage to the standard
voltage.
Standard voltage
2.8 V or more
5. If not as specified, replace the transmitter battery.
6. If as specified and the keyless entry system does
not function, perform to symptom troubleshooting.
(Refer to 0 9 -0 1 E FOREWORD.)
0 9 -1 4 -1 0