Mazda MX-6 1998, Workshop Manual, Page: 1255 / 1282

ENTERTAINMENT
AUDIO UNIT INSTALLATION
Caution
•
Make certain that the wiring harness and
antenna feeder are not caught between the
unit and dashboard. If the harness or the
antenna feeder is caught between the unit
and dashboard, it may become the cause
of trouble or malfunctions.
• To install audio unit, be sure to push
service hole cover areas on both sides of
the audio unit. If switches are pressed
instead, it may become the cause of
trouble or malfunctions.
W 6 U 9 2 0 W 1 8
1. Connect the connectors and antenna jack.
2. Insert the unit until each clip click.
3. Install the service hole covers.
4. Connect the negative battery cable.
CIGARETTE LIGHTER INSPECTION
1. Remove the socket. (Refer to 09-20 CIGARETTE
LIGHTER REMOVAL/INSTALLATION.)
2. Verify the bimetals in the socket are not warped.
3. Check if the backs of the bimetals can be seen
from the inside or outside.
W 6 U 9 2 0 W 1 9
4. If the back of the bimetal can be seen from the
inside, replace the socket.
N O R M A L
D E F E C T IV E
B IM E TA L B A C K
W 6 U 9 2 0 W A P
CIGARETTE LIGHTER REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the center panel. (Refer to 09-17
CENTER PANEL REMOVAL/INSTALLATION.)
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
W 6 U 9 2 0 W 2 0
Socket Removal Note
1. Pry up the stopper with the tape-wrapped flathead
screwdriver.
2. Pull the socket with keeping to pry up the stopper.
W 6 U 9 2 0 W A Q
1
Cigarette lighter plug
2
Socket
c? Removal Note
0 9 -2 0 -9