Mazda MX-6 1998, Workshop Manual

Page: 1233 / 1282

LIGHTING SYSTEMS
FLASHER UNIT INSPECTION
W 6 U 9 1 8 W 2 2
1. Measure the voltage at the flasher unit terminals as indicated below.
2. Disconnect the flasher unit connector before checking for continuity at terminal B.
3. If not as specified, inspect the parts listed under “ Inspection area” and the related wiring harnesses.
4. If the parts and wiring harnesses are okay but the system still does not work properly, replace the flasher unit.
Terminal Voltage List (Reference)
XZL
G E C A
H F D B
W 6 U 9 1 8 W A P
Terminal Signal Connection Test condition
Voltage (V)/
Continuity
Inspection area
A Power supply
HAZARD 15 A
fuse
Constant B+
HAZARD 15 A
fuse
B
Flasher unit
ground
GND
Constant: check for continuity to
ground
Yes GND
C
Hazard warning
on
Hazard warning
switch
Hazard warning switch on
0
Hazard warning
switch
Hazard warning switch off B+
D
Turn switch on/off
(RH)
Turn switch (RH)
Ignition switch at ON and turn
switch (RH) on
B+
Turn switch
Other 0
E
Turn signal flasher
(RH)
Turn signal light
(RH)
Ignition switch at ON and turn
signal light (RH) flashes Alternates
0 and B+
Turn signal light
(RH)
Other
0
F
Turn switch on/off
(LH)
Turn switch (LH)
Ignition switch at ON and turn
switch (LH) on
B+
Turn switch
Other 0
G
— Not used — —
—
H
Turn signal flasher
(LH)
Turn signal light
(LH)
Ignition switch at ON and turn
signal light (LH) flashes
Alternates
0 and B+
Turn signal light
(LH)
Other
0
INTERIOR LIGHT REMOVAL/INSTALLATION
W 6 U 9 1 8 W 2 3
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Note
• For type A interior light, to remove the bulb
move bulb gently to the left or right using a
small screwdriver and pull down out of the
clip. To install new bulb loop a small rubber
band around the bulb to hold it secure as it is
positioned in one of the clips. Then with the
assistance of the rubber band move bulb over
to go into the remaining clip.
• When bulb is in both clips, carefully remove
the rubber band. Gently bend the two clips
outward using the screwdriver, to secure bulb.
0 9 -1 8 -1 0