Mazda MX-6 1998, Workshop Manual, Page: 956 / 1282

TROUBLESHOOTING [AIR BAG SYSTEM]
STEP INSPECTION
ACTION
Connect leads of SST (Fuel And Thermometer
checker) to terminals 3B and 3C of clock spring.
Set resistance of
SST (Fuel And Thermometer
checker) to 2 ohms.
Connect negative battery cable.
Is DTC 6 indicated when ignition switch is turned
to ON?
Yes Go to next step.
No
Replace driver-side air bag module.
p r 0 8 -1 0 D R IV E R -S ID E AIR BAG M O D U LE
REM O VAL/INSTALLATIO N
Turn ignition switch to LOCK.
Disconnect negative battery cable and wait for
more than 1 minute to allow backup power
supply of SAS unit to deplete its stored power.
Disconnect clock spring connector.
Is clock spring connector pin okay?
Yes Go to next step.
No
Replace dash harness of air bag system.
W 6 U 8 0 1 W A B
Connect leads of SST (Fuel And Thermometer
checker) to terminals A and B of the clock spring
connector.
Set resistance of
SST (Fuel And Thermometer
checker) to 2 ohms.
Connect negative battery cable.
Is DTC 6 indicated when ignition switch is turned
to ON?
Yes Go to next step.
No Replace clock spring.
c r 0 8 -1 0 CLOCK SPRING REMOVAL/INSTALLATION
W 6 U 8 0 1 W A C
W 6 U 8 0 1 W A A
0 8 -0 1 A -6