Mazda MX-6 1998, Workshop Manual

Page: 1203 / 1282

EXTERIOR TRIM
FRONT FLAP REMOVAL/INSTALLATION
1. Remove the screws.
2. Remove the fastener.
3. Remove the front flap.
W 6 U 9 1 6 W 0 4
W 6 U 9 1 6 W A 2
4. Install in the reverse order of removal.
COWL GRILLE REMOVAL/INSTALLATION
1. Remove the windshield wiper arm and blade.
(Refer to 0 9 -1 9 WINDSHIELD WIPER ARM AND
BLADE REMOVAL/INSTALLATION.)
2. Pull the cowl grille weatherstrip to disengage clips
B from the body.
3. Remove the caps.
4. Remove the screws.
5. Pull the cowl grille to disengage clips A from the
body.
W 6 U 9 1 6 W 0 5
REAR FINISHER REMOVAL/INSTALLATION
1. Remove the screws and bolts and nuts.
2. Pull the rear finisher to disengage clips A and pins
B from the body.
W 6 U 9 1 6 W 0 6
3. Install in the reverse order of removal.
SIDE PROTECTOR No.1, No.2 REMOVAL
1 . Pry the side protector end 20— 30 mm
{0.79— 1.18 in} by using a flathead screwdriver or
a razor knife.
2. Pull the side protector forward to remove it.
W 6 U 9 1 6 W 0 7
Note
• The side protector is installed with
double-sided adhesive tape. If the side
protector is difficult to remove, soften the
double-sided adhesive tape by using a hot air
blower.
0 9 -1 6 -2