Mazda MX-6 1998, Workshop Manual

Page: 408 / 1282

MECHANICAL [FS]
13. Connect the ignition coil connector. Tightening torque
14. Install the fuel pump relay. 15—22 N-m {1.5— 2.3 kgf-m, 11— 16 ftlb f}
15. Install the spark plugs.
TIMING BELT REMOVAL/INSTALLATION [FS]
W 6 U 1 1 0 W 0 6
1. Disconnect the negative battery cable.
2. Remove the camshaft position sensor and crankshaft position sensor.
3. Remove the spark plug.
4. Remove the P/S oil pump and bracket with the oil hose still connected.
5. Remove in the order indicated in the table.
6. Install in the reverse order of removal.
7. Verify the air gap. (Refer to 01-40A CRANKSHAFT POSITION SENSOR INSPECTION [FS].)
8. Start the engine and
(1) Inspect for the pulleys and drive belt for runout and contact.
(2) Verify the ignition timing. (Refer to 01-1 OA ENGINE TUNE-UP [FS], Ignition Timing.)
6 .9 — 9 .8 N m
7 .9 — 1 0 .7 N m {7 0 — 1 0 0 k g f c m , 6 0 .8 — 8 6 .8 in lb f)
3 8 — 51 {3 .8 — 5 .3 , 2 8 — 3 8 } N m {k g f-m , ft lb f}
W 6 U 1 1 0 W A F
1 Drive belt
r
t
0 1 -10A DRIVE BELT ADJUSTMENT [FS]
2 Water pump pulley
o - Installation Note
3 Crankshaft pulley
tr Removal Note
tr Installation Note
4 Guide plate
5 Cylinder head cover
w Removal Note
zr Installation Note
6 Dipstick and pipe
7 Timing belt cover
8 No.3 engine mount rubber
o - Removal Note
9 Timing belt
tr
Removal Note
cp Installation Note
10
Tensioner, tensioner spring
tr Installation Note
11 Idler
0 1 -1 0 A -5