Mazda MX-6 1998, Workshop Manual

Page: 874 / 1282

AUTOMATIC TRANSAXLE SHIFT MECHANISM
Indicator Panel Removal Note
Remove the indicator screws and lift up the indicator
panel.
Selector Lever Removal Note
1. Slide the lock cover.
2. Disconnect the set button.
3. Remove the selector lever.
4. Pull out the selector cable from the selector lever.
5. Remove the interlock cable from the selector
lever.
Selector Cable Removal Note
1. Disconnect the selector cable from the manual
shaft lever on the transaxle.
2. Pull out the selector cable from the cable bracket
and remove it.
Interlock Cable Installation Note
1. Verify that the ignition switch is in LOCK position,
and shift the selector lever in P position.
2. Install the lock unit.
Tightening torque
4.3—6.2 N m {43—63 kgfcm , 38— 54 in lb f}
LOCK UNIT
W 6 U 5 1 8 W A B
3. Install the interlock cable, (key side)
Tightening torque
4.3— 6.2 N m (43—63 kgf cm, 38— 54 in lbf}
W 6 U 5 1 8 W A C
4. Install the interlock cable (selector lever side) onto
the interlock cam on the selector lever.
5. Fit the interlock cable in the U-grove in the
selector lever base plate.
W 6 U 5 1 8 W A D
Caution
•
Applying load to the interlock cable while
pressing the lock piece in can affect the
lock unit operation.
Note
• Step 6 and 7 are for the interlock cable
replacement only.
0 5 -1 8 -4