Mazda MX-6 1998, Workshop Manual

Page: 854 / 1282

AUTOMATIC TRANSAXLE [GF4A-EL]
T R A N S A X L E F L U ID T E M P E R A T U R E S E N S O R R E M O V A L /IN S T A L L A T IO N [G F 4 A -E L ]
W 6 U 5 1 7 W 2 1
3. Remove the transaxle fluid temperature sensor by
using the SST.
4. Install a new transaxle fluid temperature sensor by
using the SST.
1. Remove the control valve body cover. (Refer to
0 5 -1 7B CONTROL VALVE BODY
REMOVAL/INSTALLATION [GF4A-EL].)
2. Disconnect the transaxle fluid temperature sensor
connector.
Tightening torque
7.9— 10.7 N m
{80— 110 kgf-cm, 69.5— 95.4 in lbf}
5. Connect the transaxle fluid temperature sensor
connector.
6. Install the control valve body cover. (Refer to
0 5 -1 7B CONTROL VALVE BODY
REMOVAL/INSTALLATION [GF4A-EL].)
7. Carry out the line pressure test. (Refer to 0 5 -1 7B
MECHANICAL SYSTEM TEST [GF4A-EL], Line
Pressure Test.)
INPUT/TURBINE SPEED SENSOR INSPECTION [GF4A-EL]
1. Disconnect the negative battery cable.
2. Remove the resonance chamber, fresh-air duct,
and air cleaner component. (Refer to 0 1 -1
3B
INTAKE-AIR SYSTEM
REMOVAL/INSTALLATION
[K L ].)
3. Remove the fuel filter mounting nuts.
4. Disconnect the input/turbine speed sensor
connector.
5. Measure resistance between the terminals of the
input/turbine speed sensor.
Resistance (ATF temperature: -4 0 — 160 °C
{-4 0 — 320 °F})
253— 604
Q
6 .
7.
8
.
9.
10 .
W 6 U 5 1 7 W 2 2
If not correct, replace the input/turbine speed
sensor.
Connect the input/turbine speed sensor connector.
Install the fuel filter mounting nuts.
Install the air cleaner component, fresh-air duct,
and resonance chamber. (Refer to 01- 13B
INTAKE-AIR SYSTEM
REMOVAL/INSTALLATION [KL].)
Connect the negative battery cable.
W 6 U 5 1 7 W D D
0 5 -1 7 B -1 4