Mazda MX-6 1998, Workshop Manual, Page: 822 / 1282

AUTOMATIC TRANSAXLE [LA4A-EL]
8. Hand tighten the two mounting bolts.
9. Use the
SST to align the switch on the shaft and
case.
10. Tighten the two mounting bolts.
Tightening torque
11— 13 N m {112— 133 kgf cm, 96— 117 in lbf}
11. Connect the transaxle range switch connector.
12. Install the air cleaner component, fresh-air duct.
(Refer to 0 1 -1 3A INTAKE-AIR SYSTEM
REMOVAL/INSTALLATION [FS].)
13. Install the battery component. (Refer to 01-17
BATTERY REMOVAL/INSTALLATION.)
14. Connect the negative battery cable.
O/D OFF SWITCH INSPECTION [LA4A-EL]
W 6 U 5 1 7 W 4 1
Refer to 0 5 -1 7B O/D OFF SWITCH INSPECTION [GF4A-EL],
O/D OFF SWITCH REMOVAL/INSTALLATION [LA4A-EL]
W 6 U 5 1 7 W 4 2
Refer to 0 5 -1 7B O/D OFF SWITCH REMOVAL/INSTALLATION [GF4A-EL],
VEHICLE SPEEDOMETER SENSOR INSPECTION [LA4A-EL]
W 6 U 5 1 7 W 4 3
1. Remove the vehicle speedometer sensor. (Refer
to 0 5 -1 7A VEHICLE SPEEDOMETER SENSOR
REMOVAL/INSTALLATION [LA4A-EL].)
W 6 U 5 1 7 W F A
2. Measure the voltage between terminals of the
vehicle speedometer sensor while rotating the
driven gear.
M eter needle
A c tio n
Moves slightly under 5 V
Repair wiring harness
(Instrument cluster— Vehicle
speedometer sensor)
Does not move
Replace vehicle speedometer
sensor
W 6 U 5 1 7 W D H
3. Install the vehicle speedometer sensor. (Refer to
0 5 -1 7A VEHICLE SPEEDOMETER SENSOR
REMOVAL/INSTALLATION [LA4A-EL].)
0 5 -1 7 A -1 7