R&S ZVL
Command Reference
Instrument-Control Commands
Operating Manual 1303.6580.32-05
375
Query the results of the bandfilter search. An error message is generated if
the bandfilter search fails so that no valid results are available.
CALCulate<Chn>:MARKer<Mk>:COUPled[:STATe] <Boolean>
Couples the markers of all traces in the active setup to the markers of trace no. <Chn>, provided that they
have the same sweep type (
SENSe<Chn>:FUNCtion
).
<Chn>
Channel number used to identify the active trace. The effects of marker coupling
depend on the active trace number; see
Coupled Markers
in the GUI Reference
chapter.
<Mk>
Marker number in the range 1 to 10. This suffix is ignored because the command
affects all markers.
<Boolean>
ON | OFF - Enables or disables marker coupling.
*RST value
OFF
SCPI,
Command
Types
Device-specific, command or query.
Example:
Suppose that the active setup contains two traces Trc1 and Trc2, assigned to
channels no. 1 and 2, respectively.
:CALC1:PAR:SEL 'TRC1'; CALC1:MARK1 ON; MARK2 ON
Select Trc1 as the active trace and create the two markers no. 1 and 2. The
default position for both markers is the center of the sweep range.
CALC1:MARK:COUP ON
Create two markers no. 1 and 2 on Trc 2 and couple them to the markers of Trc 1.
CALCulate<Chn>:MARKer<Mk>:DELTa[:STATe] <Boolean>
Switches the delta mode for marker <Mk> on trace no. <Chn> on or off. The marker must be created
before using
CALCulate<Chn>:MARKer<Mk>[:STATe] ON
. If the active trace contains no reference
marker, the command also creates a reference marker.
<Chn>
Channel number used to identify the active trace.
<Mk>
Marker number in the range 1 to 10.
<Boolean>
ON | OFF - Enables or disables the delta mode.
*RST value
OFF
SCPI, Command
Types
Device-specific, command or query.
Example:
Suppose that the active setup contains an active trace no. 1.
CALC:MARK ON
Create marker no. 1 and set it to the center of the sweep range.
CALC:MARK:DELT ON
