R&S ZVL
GUI Reference
Trace Menu
Operating Manual 1303.6580.32-06
159
Remote control:
CALCulate<Chn>:PHOLd MAX | OFF
Marker ->
The
Marker ->
submenu uses the active marker to define the sweep range, scale the diagram and
introduce an electrical length offset.
The functions in the upper section provide search functions to locate specific points on the trace.
•
Marker Search
opens a submenu with all marker search functions.
•
Max Search
sets the active marker to the
absolute maximum in the search range.
•
Next Peak
sets the active marker to the next maximum or minimum in the search range,
depending on the current search criterion.
The following functions use the stimulus value of the active marker to define the sweep range:
•
Start = Marker
sets the beginning of the sweep range equal to the marker value.
•
Stop = Marker
sets the end of the sweep range equal to the marker value.
•
Center = Marker
sets the center of the sweep range equal to the marker value.
The following functions use the response value of the active marker to scale the y-axis of the diagram
:
•
Ref. Value = Marker
sets the reference value equal to the marker value.
•
Max = Marker
sets the upper edge of the diagram equal to the marker value.
•
Min = Marker
sets the lower edge of the diagram equal to the marker value.
•
Zero Delay at Marker
corrects the
measurement result by adding or subtracting a constant group
delay.
Next Peak
Sets the active marker to the next maximum or minimum in the search range, depending on the current
search criterion.
•
If a
Max Search
or a
Bandpass Search
is active, then the marker is set to the next maximum. The
next maximum is the maximum with the largest response value that is below the current marker
response value.
•
If a
Min Search
or a
Bandstop Search
is active, then the marker is set to the next minimum. The
next minimum is the minimum with the smallest response value that is above the current marker
response value.
