R&S ZVL
Measurement Examples
Advanced Tasks
Operating Manual 1303.6580.32-05
111
To prepare the distance-to-fault measurement, first perform a full one-port calibration at PORT 2:
Press the
Preset
key to restore standard analyzer settings, in particular a linear frequency sweep with
a relatively wide sweep range and a sufficiently large number of points.
Click
Trace – Meas – Distance-to-Fault
to switch on the distance-to-fault measurement, display the
distance scale and select S22 as measured quantity.
Click
Trace – Meas – Distance-to-Fault – Full One-Port P2 Cal...
to open the calibration wizard and
perform a full one-port calibration at the analyzer test port. Proceed in analogy to section
Manual_calibration, connecting the required Open, Short, and Match standards directly to PORT 2.
Click
Cable Type
to open the
Cable Type
dialog. In the list of cables, select your cable type
(RG
141A).
Press
OK
to close the dialog.
Adjust the
Stop Distance
to 3 m, according to the dimensions of your cables (approx. twice the total
length in order to view multiple reflections)
.
Observe the measurement result in the diagram area (see Analysis of Distance-to-Fault Results). If
desired, vary the diagram scale
(Trace – Scale...).
If the second cable is of different type, you can still correctly locate the fault on the first cable using the
described settings. If your cable type is not in the list, you can easily add your own cable type with
arbitrary properties.
Analysis of Distance-to-Fault Results
The position of the spikes indicating faults and discontinuities is most easily monitored using markers
which are placed onto the peaks of the trace
(Trace – Marker – Marker Search – Peak Search >)
. With a
matched termination at the end of the second cable, the following result is obtained:
The spikes can be interpreted as follows:
•
Mkr 1
shows the position of the first adapter between the analyzer port and the first cable.
