![background image](http://html1.mh-extra.com/html/omron/cj1w-nc271-12-2009/cj1w-nc271-12-2009_operation-manual_742348321.webp)
293
Origin Search Operation
Section 8-2
For G5-series Servo Drives, G-series Servo Drives and W-series Servo
Drives used with incremental encoders or absolute encoders used as incre-
mental encoders, the present position is taken as 0 when the power is turned
ON. When the executable functions shown in the above table are executed by
the PCU without a defined origin, the present position will be calculated from
the position of the axis (0) when the power was turned ON with no origin
established.
8-2
Origin Search Operation
8-2-1
Origin Search Overview
Origin searches are performed by actually operating the Servomotor, search-
ing for the mechanical origin based on the limit input signal, origin proximity
input signal, and origin input signal, and to define the origin.
Note
In ORIGIN SEARCH execution, the present position is cleared to 0 at the
same time when an origin is defined. Unless the Absolute Encoder Zero Point
Position Offset is set using an Origin Search Operation with Position Control
Units with unit version 2.0 or later, the absolute value data read to the PCU
when SERVO LOCK was executed will be lost when the origin is established.
(The absolute data saved in the absolute encoder will not be lost and can be
obtained by executing SERVO LOCK after SERVO UNLOCK.) When using a
Position Control Unit with unit version 2.0 or later and not setting an Absolute
Encoder Zero Point Position Offset, execute ORIGIN SEARCH using either a
Servomotor with incremental encoder or a Servomotor with absolute encoder
that is used as an incremental encoder.
Position
control
ABSOLUTE MOVE-
MENT
Cannot be executed.
If executed, a Present Position Unknown Error
(axis error code: 3030 hex) will occur.
RELATIVE MOVE-
MENT
Can be executed.
INTERRUPT FEED-
ING
Can be executed only with RELATIVE MOVE-
MENT.
If executed with ABSOLUTE MOVEMENT, a
Present Position Unknown Error (axis error
code: 3030 hex) will occur, and the function will
not be executed.
SPEED CONTROL
Can be executed.
TORQUE CONTROL
Can be executed.
Function
Operation
Содержание CJ1W-NC271 - 12-2009
